Thermocouple wiring diagram
This document provides step-by-step instructions for wiring and configuring your NI DAQ device for use with a thermocouple. Before you begin using your NI DAQ hardware, you must install your
application development environment (ADE) and NI-DAQmx driver software. The P470 is a standalone 8-channel thermocouple simulator. It is intended for system-level testing of process control systems, FADEC engine controllers, and other critical systems. Type J (Iron / Constantan) Limited range (-40 to +750°C) makes type J less popular than type K. The main application is with old equipment that cannot accept 'modern' thermocouples. Thermocouples, Thermocouple, TC Supply. © Temperature Controls Pty Ltd. All
equipment 75-551.5 A Problem/Remedy Guide for Modine: Gas-Fired Unit Heaters Gas-Fired Duct Furnaces I also have an old series 600 heater from sears. I found a book either on the Kenmore or sears site for a 600 model number 867.736349 and 867.736389 and although my model was 867.73361, the wiring was practically identical.